CNC machine tool hydraulic system fault handling method
In the previous article,we explained to you the common faults of the hydraulic system of CNC lathes.We all know the importance of the hydraulic system,but we did not share the method for you.Xiaobian deliberately went to find information and found it for everyone.The following processing method.
1.Fault treatment of oil pollution
For the occurrence of oil pollution,it is necessary to strengthen the relevant finishing methods in daily protection and reduce the problem of oil pollution.Reasonable inspection of the assembly components of the system to avoid contamination of the components.Others also need to arrange professional personnel to carry out the cleaning of the hydraulic system to minimize the degree of oil pollution.The personnel can also use the advanced skills to detect the particulate pollutants in the oil,turbine oil and other oils used in the hydraulic oil control system by using the wild particle pollution detector to avoid the phenomenon of excessive pollutants.
2,hydraulic system sensation and noise processing
The sensation of the hydraulic system and the occurrence of noise are mainly caused by the wear of the components in the hydraulic system.If you want to reduce the sensation and noise demand to strengthen the protection of the components,the hydraulic system can use low-noise hydraulic components,reduce the vibration source,lower the hydraulic pressure.The noise of the system.In order to reduce the noise,it is possible to install a silencer in the hydraulic system of the CNC machine tool,which can effectively reduce the noise.In the future,it is necessary to further improve the equipment of the hydraulic system,and the protection and maintenance personnel will replace some of the components that present the problem in time to avoid system sensation and noise caused by component problems.
3,the treatment of hydraulic system defects
Because the cause of the hydraulic system is different,different methods are needed for the correction of this problem.Because the hydraulic system will take some time to wear some components,it is necessary to replace the components of the system with time to reduce the defects caused by component problems.Others for the defects caused by poor driving ability,can continuously improve the processing accuracy in the production process of the parts,strictly check every part of the system,add some valves in the hydraulic system to ensure sufficient oil in the system,in the hydraulic system Add the corresponding exhaust valve or bleed valve to avoid vacuum in the system.
In fact,to put it bluntly,the most fundamental method is not to do the maintenance work of the hydraulic system.It is because it belongs to the maintenance,and various problems will arise.The best solution is to prevent it from happening.Good maintenance on weekdays.